356 datasets found

In the KTB field laboratory, porosity, internal surface and permeability were determined on identical mini cores with 25.4 mm in diameter and approximately 50 mm in length....

These data are supplementary material to “Bedrock Geology of DFDP-2B, Central Alpine Fault, New Zealand” (Toy et al., 2017, http://doi.org/10.1080/00288306.2017.1375533). The...

Increased presence of greigite (high SIRM/κLF) coincides with maximum sulphur contents observed at the beginning of interglacial stages (Fig. 11A). At similar levels in another...

The density of rocks depends on the mineral contents and is therefore a helpful property for the discrimination of lithological units. It is also used for the calculation of...

In the KTB field laboratory, thermal conductivity was measured on cuttings material in depth intervals of 10 m and on available drill core material. The results on drill cores...

Cuttings were crushed in a tungsten carbide ball mill for 25 min; while core samples were crushed in a tungsten carbide jaw breaker and then processed in the same way as the...

Geochemical Analysis of Cations of Mud Samples of the KTB Main Hole HB1g.

In all abyssal stations, densities are never over an average of c. 3100 individuals m−2 (Fig. 3, Table 1). In contrast, the shallow station (CON01-427, Posolskoe Bank) harbours...

The main objective of this drilling fluid analysis was the detection of inflows of formation fluids. Therefore different gases dissolved in the drilling mud were measured...

The magnetic susceptibility is measured by an inductive AC device (BARTINGTON). The sample is placed inside a coil which generates an alternating magnetic field. The applied...

Geochemical Analysis of Cations of Mud Samples of the KTB Main Hole HB1h.

In the KTB field laboratory, porosity, internal surface and permeability were determined on identical mini cores with 25.4 mm in diameter and approximately 50 mm in length....

The magnetic susceptibility is measured by an inductive AC device (BARTINGTON). The sample is placed inside a coil which generates an alternating magnetic field. The applied...

Wet bulk density of pilot core to CON01-603-2 (CONTINENT Ridge) measured by GRAPE density

Preservation differences can be used as correction factors to recalculate the relative abundances of each of the five dominant plankton taxa in BAIK38 and are depicted in Fig....

Opal content was obtained by measuring the NaCO3 leached solution by inductive coupled plasma with an optical emission spectrometer (ICP-OES). The clay-rich layers are...

Sediment slices of 0.5 cm thickness were obtained from gravity core segments and of 1 cm thickness from the Vydrino piston core. Volumetric subsamples of 5 cm3 (10 cm3 in case...

Cuttings were crushed in a tungsten carbide ball mill for 25 min; while core samples were crushed in a tungsten carbide jaw breaker and then processed in the same way as the...

Wet bulk density of core CON01-605-2a, the trigger core to piston core CON01-605-2 at Vydrino

In general, four-electrode devices are used to measure the resistivity on original (unprepared) cores and on mini cores drilled from these original cores. The in-phase and the...