356 datasets found

Water content and dry bulk density of piston core CON01-603-2 from CONTINENT Ridge

The magnetic susceptibility is measured by an inductive AC device (BARTINGTON). The sample is placed inside a coil which generates an alternating magnetic field. The applied...

Geochemistry of sediment core BDP-2-A ( BDP96-1) from Lake Baikal

In order to get a complete geochemical signature, 14 P-rich concretions, chosen among the different cores, were acid digested (Table 3a and Table 3b). In a clean laboratory, 1.7...

The qualitative and quantitative phase analyses were performed in the KTB field laboratory by x-ray powder diffraction using SIEMENS D 500 diffractometer. During early stages of...

The traps were deployed for about 16 months. The respective regression equations and its coefficients of determination (r2) are reported in Table 5.In the 40-m trap, fucoxanthin...

Water content and dry bulk density of pilot core CON01-605-3a to piston core CON01-605-3 at Vydrino

The temperature pattern is attributed to a superposition of thermal and hydraulic processes. In the deeper borehole (HSDP-2, depth 3.1 km) detailed temperature monitoring was...

Cuttings were crushed in a tungsten carbide ball mill for 25 min; while core samples were crushed in a tungsten carbide jaw breaker and then processed in the same way as the...

The water content was determined from samples retrieved with cylindrical syringe samplers, weighed wet and weighed again after freeze-drying. The clay-rich layers are...

In the laboratory, the gamma radiation is measured by a sodium iodtite (NaI) scintillation detector (cores and cuttings) and by a germanium (Ge) semiconductor detector...

The density of rocks depends on the mineral contents and is therefore a helpful property for the discrimination of lithological units. It is also used for the calculation of...

The main objective of this drilling fluid analysis was the detection of inflows of formation fluids. Therefore different gases dissolved in the drilling mud were measured...

In the complete KTB-VB and in in the KTB-HB down to a depth of 3003 m the gas phase was released and collected by twirl degassers attached in front of the mud shakers. This open...

SAFOD is motivated by the need to answer fundamental questions about the physical and chemical processes controlling faulting and earthquake generation within a major...

SAFOD is motivated by the need to answer fundamental questions about the physical and chemical processes controlling faulting and earthquake generation within a major...

Palaeomagnetism was the method used for dating sediments older than the time span covered by AMS 14C dating. Geomagnetic palaeointensities recorded in Lake Baikal sediments were...

In general, four-electrode devices are used to measure the resistivity on original (unprepared) cores and on mini cores drilled from these original cores. The in-phase and the...

Ultrasonic wave propagation through core samples is studied in a water tank to insure good signal transmission between transducer, rock specimen and receiver and to avoid time -...

Cuttings were crushed in a tungsten carbide ball mill for 25 min; while core samples were crushed in a tungsten carbide jaw breaker and then processed in the same way as the...