This series is composed of five select physical marine parameters (water salinity and water temperature for surface and near bottom waters and sea ice) for two climate scenarios (RCP 45 and RCP 8.5) and three statistics (minimum, median and maximum) from an ensemble of five downscaled global climate models. The source data for this data series is global climate model outcomes from the Coupled Model Intercomparison Project 5 (CMIP5) published by the Intergovernmental Panel on Climate Change (Stocker et al 2013). The source data were provided in NetCDF format for each of the downsampled climate models based on the five CMIP5 global climate models: MPI: MPI-ESM-LR, HAD: HadGEM2-ES, ECE: EC-EARTH, GFD: GFDL-ESM2M, IPS: IPSL-CM5A-MR. The data included monthly mean, maximum, minimum and standard deviation calculations and the physical variables provided with the climate scenario models included sea ice cover, water temperature, water salinity, sea level and current strength (as two vectors) as well as a range of derived biogeochemical variables (O2, PO4, NO3, NH4, Secci Depth and Phytoplankton). These global atmospheric climate model data were subsequently downscaled from global to regional scale and incorporated into the high-resolution ocean–sea ice–atmosphere model RCA4–NEMO by the Swedish Meteorological and Hydrological Institute (Gröger et al 2019) thus providing a wide range of marine specific parameters. The Swedish Geological Survey used these data in the form of monthly mean averages to calculate change in multi-annual (30-year) climate averages from the beginning and end of the 21st century for the five select parameters as proxies for climate change pressures. Each dataset uses only source data models based on an assumption of atmospheric climate gas concentrations in line with either the IPCCs representative concentration pathway RCP 4.5 or RCP 8.5. Changes were calculated as the difference between two multiannual (30 year) mean averages; one for a historical reference climate period (1976-2005) and one for an end of century projection (2070-2099). These data were extracted for each of the five downscaled CMIP5 models individually and then combined into ensemble summary statistics (ensemble minimum, median and maximum). In the Ensemble_Maximum/Median/Minimum_Rasters datasets, changes in mean (May-Sept) surface temperature and bottom temperature are given in Degrees Celsia (°C); changes in mean annual surface salinity and bottom salinity are given in Practical Salinity Units (PSU); changes in mean (October-April) sea ice are given in Percentage Points (pp). In the Normalized_Rasters datasets, the changes are normalized using a linear stretch so that a cell value of zero represents no projected and a cell value of 100 represents a value equal to or above the mean change in Swedish national waters. The values representing 100 are: 4 °C for surface temperature; 3 °C for bottom temperature; -1.5 PSU for surface salinity; -2.0 PSU for bottom salinity; and -40 pp for sea ice. These were also the chosen reference values for determining, via expert review, the sensitivity of ecosystem components to changes in these parameters (for further information refer to the Symphony method). Notes on interpretation. This dataset does not highlight inter-annual or inter-decadal climate variability (e.g. extreme events) or changes in biochemical parameters (e.g. O2, chlorophyll, secchi depth etc) resulting from change in surface temperature. Areas of no-data inshore were filled using extrapolating from nearby cells (using similar depths for benthic data) so data near the coast and particularly within archipelagos, bays and estuaries is not robust. Users should refer to the associated climemarine uncertainty map for this parameter. The uncertainty map shows the interquatile range from the climate ensemble and the area of no-data as 'interpolated values'. For any application which requires more temporally or spatially explicit information (e.g. at sub/national decision making) it is highly recommended that the user contact SMHI for access to the latest climate model source data (in NetCDF format) which contains much more detail and a far wider selection of parameters. For regional applications (e.g. at the scale of the Baltic Sea) - it should be noted that these data will likely require normalisation to regional rather than national values and that sensitivity scores used may differ. ClimeMarine was selective in its choice of pressure parameters. SMHI have additional data available for other parameters such as O2, secchi depth and nutrients which could be included in future. This is complicated because many parameters are influenced by riverine discharge and therefore by decisions related to watershed management - disentanglement of impacts from climate vs river basin management becomes a complication. In a similar way, data on sealevel rise is also available which could be used to estimate impacts on the coast but likewise complicating factors such as isostatic uplift and coastal defence and management policies would need to be considered. For simplicity and to reduce the amount of datasets to a manageable level for this assessment the source data were further limited and summarised in several ways: Only the monthly mean averages of seawater temperature, salinity and sea ice (i.e. key physical parameters) were utilized. For seawater salinity and temperature, the depth dimension (i.e. the water column) was summarised from 56 depth levels to just two: the surface and the deepest (bottom) waters. Only two of the three climate periods were selected: a historical reference period: 1976-2005 (to represent the current status) and the projected end of century period: 2070-2099. Only two of the three available emission scenarios were selected detailing the consequence of intermediate and very high climate gas emissions : Representative Concentration Pathway (RCP) 4.5 and 8.5 (see SEDAC 2021). Each dataset included in the series comes with extensive metadata. The data processing followed the following steps: Extraction of data for each parameter from NetCDF to TIFF Rasters for each model, emission scenario, depth level (using scripts in NCO, CDO and R). Calculation of climate ensemble statistics - Minimum, Mean, Median and Maximum (using Arcpy and Numpy) Reprojection and resampling from the 2nm NEMO-RCO from Lat/Long WGS84 grid to the 250m ETRS89 LAEA Symphony grid (using Arcpy) Extrapolation to fill no-data cells based on proximity and similar depths (using Arcpy script and the ArcGIS spatial analyst extension) Calculation of change for each parameter as the end of century multi-annual mean minus the reference multi-annual mean (using an Arcpy script) Inversion of if negative (i.e. decreases) to positive (i.e. magnitude of change) Normalisation as a linear stretch from 0 to 100 where zero equates to no change and 100 equates to the maximum pixel value in Swedish waters from the RCP 8.5 ensemble mean dataset with any values over this pixel value also set to 100 (Arcpy script) NetCDF source data used in this analysis can be requested from the Swedish Meteorological and Hydrological Institute - kundtjanst@smhi.se Processing scripts (R and arcpy) and interim raster data can be requested from the Geological Survey of Sweden - kundtjanst@sgu.se

Denna datauppsättning består av två serier av trettio raster av förändringar i 30-åriga klimatmedelvärden från början till slutet av 2000-talet för de fem utvalda fysiska marina parametrarna (vattensalthalt och vattentemperatur för yt- och bottenvatten samt havsis) och två klimatscenarier (RCP 45 och RCP 8.5). Den första serien består av raster av tre statistik (minimum, median och maximum) från en ensemble av fem nedskalade globala klimatmodeller. I den andra serien är dessa raster normaliserade så att ett värde på noll representerar ingen förändring och ett värde på 100 representerar medelförändringen i svenska nationella vatten. Se datauppsättningarnas engelska sida för en omfattande beskrivning.