-
XRD of Cores of the KTB Main Hole HB1
The qualitative and quantitative phase analyses were performed in the KTB field laboratory by x-ray powder diffraction using SIEMENS D 500 diffractometer. During early stages of... -
Thermal Conductivity of Cuttings of the KTB Main Hole HB1 (transformed data)
In the KTB field laboratory, thermal conductivity was measured on cuttings material in depth intervals of 10 m and on available drill core material. The results on drill cores... -
Natural Gamma-ray Activity of Cuttings of the KTB Main Hole HB1 (measurements...
In the laboratory, the gamma radiation is measured by a sodium iodtite (NaI) scintillation detector (cores and cuttings) and by a germanium (Ge) semiconductor detector... -
Infrared-Spectrometry on Cutting Samples of the KTB Main Hole (Drill Section ...
Infrared-Spectrometry on Cutting Samples of the KTB Main Hole (Drill Section HB1d), 6770-7218 m. -
Gas mass spectrometry of gas samples from the KTB Main Hole HB1
The main objective of this drilling fluid analysis was the detection of inflows of formation fluids. Therefore different gases dissolved in the drilling mud were measured... -
Permeability of Mini Cores of the KTB Main Hole HB1
In the KTB field laboratory, porosity, internal surface and permeability were determined on identical mini cores with 25.4 mm in diameter and approximately 50 mm in length.... -
Percent DW and %LOI values for the surface sediment core taken at site BAIK38...
Samples were routinely analysed for wet density (WD), percentage dry weight (%DW) at 105 °C, and loss-on-ignition analysis (LOI) at 550 °C, and data used to calculate diatom... -
Thermal Conductivity of Cuttings of the KTB Main Hole HB1g (measured data)
In the KTB field laboratory, thermal conductivity was measured on cuttings material in depth intervals of 10 m and on available drill core material. The results on drill cores... -
Geochemical Analysis of Cations of Mud Samples of the KTB Main Hole HB1d.
Geochemical Analysis of Cations of Mud Samples of the KTB Main Hole HB1d. -
Density of Core Samples of the KTB Main Hole HB1g
The density of rocks depends on the mineral contents and is therefore a helpful property for the discrimination of lithological units. It is also used for the calculation of... -
Age determination of sediment core BDP96-1(BDP-2-A)
Two boreholes, one to a depth of 300 m, and the other to a depth of 100 m below sediment surface were drilled at 53°41´48´´N-108°21´06´´E. The core was collected down to 200m in... -
Thermal Conductivity of Cuttings of the KTB Main Hole HB1i (measured data)
In the KTB field laboratory, thermal conductivity was measured on cuttings material in depth intervals of 10 m and on available drill core material. The results on drill cores... -
Gas Mass Spectrometry of Gas Samples of the KTB Pilot Hole VB1a
In the complete KTB-VB and in in the KTB-HB down to a depth of 3003 m the gas phase was released and collected by twirl degassers attached in front of the mud shakers. This open... -
Water content and dry bulk density of pilot core to CON01-603-2, PANGAEA
Water content and dry bulk density of pilot core to CON01-603-2 -
Thermal Conductivity of Cuttings of the KTB Main Hole HB1a (measured data)
In the KTB field laboratory, thermal conductivity was measured on cuttings material in depth intervals of 10 m and on available drill core material. The results on drill cores... -
Axial Vs on Core Samples of the KTB Main Hole HB1a
Ultrasonic wave propagation through core samples is studied in a water tank to insure good signal transmission between transducer, rock specimen and receiver and to avoid time -... -
Infrared-Spectrometry on Cutting Samples of the KTB Main Hole (Drill Section ...
Infrared-Spectrometry on Cutting Samples of the KTB Main Hole (Drill Section HB1i), 8732-9101 m. -
Natural Remanent Magnetisation of Cores of the KTB Pilot Hole VB1
Natural Remanent Magnetisation of Cores of the KTB Pilot Hole VB1 -
Gas chromatography of gas samples of the KTB pilot hole VB1a
The main objective of this drilling fluid analysis was the detection of inflows of formation fluids. Therefore different gases dissolved in the drilling mud were measured... -
Axial Vs on Core Samples of the KTB Pilot Hole VB1
Ultrasonic wave propagation through core samples is studied in a water tank to insure good signal transmission between transducer, rock specimen and receiver and to avoid time -...
