-
Sortable silt grain-size distributions, textural fractions, and derived hydro...
This dataset has no description
-
Time series of bed shear stress in the cross section of the seeding locations...
This is a data set related to a bedload tracer field study in an alpine section of the Drava River between 11 May 2017 and 11 June 2018. A time series of bed shear stress is... -
Measured friction coefficients during laboratory shear experiments
This dataset has no description
-
Raw data from experiment B707 of Alpine Fault DFDP-1B gouge (Table 6)
This dataset has no description
-
Raw data from experiment Du507 of Alpine Fault DFDP-1B gouge (Table 5)
This dataset has no description
-
Raw data from experiment Du506 of Alpine Fault DFDP-1B gouge (Table 4)
This dataset has no description
-
Raw data from experiment Du505 of Alpine Fault DFDP-1B gouge (Table 3)
This dataset has no description
-
Raw data from experiment Du504 of Alpine Fault DFDP-1B gouge (Table 2)
This dataset has no description
-
Relative slip tendency as a function of angle between SHmax and thrust strike...
For detailed description of calculation methods see Further details: "Slip tendency analysis technique - description of methods" -
(Table 2) Flow conditions and bed form dimensions used for the numerical expe...
Geocode: depth, water = mean water depth -
Stiffness calculations of samples from major plate-boundary fault zones
This dataset has no description
-
Parameters for linear stiffness fitting of samples from major plate-boundary ...
This dataset has no description
-
Measured SSE parameters of samples from major plate-boundary fault zones
This dataset has no description
-
SSE parameters of laboratory friction experiments on simulated fault gouges
This dataset has no description
-
Stick-slip parameters of laboratory friction experiments on simulated fault g...
This dataset has no description
-
Stick-slip details of samples from IODP Hole 362-U1480G (Table 6)
This dataset has no description
-
Stiffness measurements for direct-shear apparatuses
Under a wide range of conditions, we directly measure the stiffness in the shear loading direction of five direct-shear apparatuses employed in the Marine Geotechnics laboratory... -
(Table T3) Friction coefficients of ODP Hole 190-1173A
This dataset has no description
-
(Tables T38,T40,T44,T46,T50,T52) Ko-consolidated undrained test results and c...
All stresses / pressures were originally measured in ksc (kgf/cm**2). The conversion of ksc to SI units is 1 ksc = 98.07 kPa. Tables T42, T48, T54 and T56 have been omitted... -
(Table 1) Experimental details and results
Factor-of-safety analyses of submarine slope failure depend critically on the shear strength of the slope material, which is often evaluated with residual strength values and...
