-
Elemental concentrations of marine authigenic clay formation from different s...
This dataset has no description
-
Trace element chemistry for samples from the Adirondacks, New York, USA, anal...
Cl is calculated using isotope dilution based on AMS data and the methods of Faure (1983).Trace elements were analyzed by ICP-MS with detection limits (ppm) as follows: 10 for... -
In situ Be-10, Al-26, and Ne-21 measurements of detrital river sediment in ce...
We measured the concentration of in situ Be-10 and Al-26 in quartz separated from medium (250-850 micron) detrital river sand collected from 22 watersheds in central Cuba.... -
10Be/9Be ratios reveal marine authigenic clay formation
As reverse weathering has been shown to impact long-term changes in atmospheric CO2 levels, it is crucial to develop quantitative tools to reconstruct marine authigenic clay... -
Chlorine-36 concentration data for surface exposure age calculations from the...
Properties and analytical data for samples collected for chlorine-36 surface exposure ages in the Adirondack Mountains of New York, USA. Also includes the major and trace... -
Neon processing and analysis data
(1) Computed by comparison to 20Ne signal in air pipettes. 1-sigma uncertainty includes measurement uncertainty of 20Ne signal in this analysis and the reproducibility of the... -
Beryllium blank sensitivity analysis from the detrital river sediment in cent...
Beryllium blank sensitivity analysis showing comparison between using individual batch blanks and average blanks. -
Aluminium-26 and Beryllium-10 derived erosion rate from the detrital river se...
Note: * Where the 26Al/10Be ratio is significantly below 7 (see Table S7), the erosion rates are overestimes.* The CU-016 Be data are only from the duplicate sample. -
Aluminum and beryllium isotope concentrations and ratios from the detrital ri...
= We used only the DUP Be-10 measurement because we re-leached the sample and concluded the first one was not clean enough. -
Aluminum isotope measurements from the detrital river sediment in central Cuba
This dataset has no description
-
Beryllium isotope measurements from the detrital river sediment in central Cuba
Isotopic analysis was conducted at PRIME Laboratory; ratios were normalized against standard 07KNSTD3110 with an assumed ratio of 2850 x 10^-15 (Nishiizumi et al., 2007). -
Blank data for aluminum measurements
This dataset has no description
-
Blank data for beryllium measurements
This dataset has no description
-
Percentage of each basin underlain by different lithologic units of each samp...
This dataset has no description
-
Sample information from each sample from the detrital river sediment in centr...
This dataset has no description
-
Major element chemistry for samples from the Adirondacks, New York, USA, anal...
All major element chemistry and LOI is listed in weight percent and was performed with X-ray fluorescence with 0.01% detection limit.H2O and CO2 were each assumed to account for... -
Properties and analytical data for samples from the Adirondacks, New York, US...
This dataset has no description
-
Erosion rates from the detrital river sediment in central Cuba
The different erosion rate estimates have two different types of differences. One is that they were calculated using different isotopes in the rocks (26Al and 10Be). These are... -
CRONUS Input of all samples from the detrital river sediment in central Cuba
Input data table for the online calculator described by Balco et al. (2008) (hess.ess.washington.edu) and subsequently updated. Note: This table is set up so that you can open... -
XRD data of marine authigenic clay formation from different samples
This dataset has no description
