-
(Table 2) Minerals at DSDP Hole 79-544A
Assuming Fe2O3 = 15% total Fe. -
(Table 2) Heavy mineral composition of 0.25-0.05 mm grain size fraction from ...
This dataset has no description
-
(Table 2) Heavy mineral composition of 0.25-0.05 mm grain size fraction from ...
This dataset has no description
-
Sequential Fe extraction of sediment core HE376/07-2
This dataset has no description
-
(Table 1) Alteration mineralogy of ODP Hole 140-504B samples
This dataset has no description
-
(Table 1) Mineralogy of ODP Leg 135 vitrophyric rhyolite samples
This dataset has no description
-
(Table 1) Mineralogy of ODP Leg 135 samples
This dataset has no description
-
(Table T8) Whole-rock geochemical composition of ODP Hole 176-735B gabbros
This dataset has no description
-
(Table 4) Representative plagioclase and oxide compositions from basaltic, ga...
This dataset has no description
-
(Table T2) Modal mineralogy of ODP Hole 118-735B
Sediment depth is given in mbsf. All values in modal %. -
(Table 5) Mineralogical occurrence and distribution in ODP Site 134-833 volca...
Sediment depth is given in mbsf. + = present, - = absent. -
(Table 1) Mineralogical occurrence and distribution in ODP Site 134-832 volca...
Sediment depth is given in mbsf. + = present, - = absent. -
(Table 2) Geochemistry of ash and pumice of ODP Hole 132-810C
Sediment depth is given in mbsf. Analyses are listed normalized to 100%, based on the summation Elements, total as reported. Mg# and CIPW norms are calculated assuming Fe /(Fe +... -
(Table 4) Iron geochemistry of micro-drilled mesh-rims of ODP Hole 209-1274A
This dataset has no description
-
(Table T1) Geochemistry of variably altered dacite from several ODP Leg 193 s...
Sediment depth is given in mbsf. Silicate d18O measurements were made on sulfate-free bulk rock powders. Where present, anhydrite was removed prior to analysis. For anhydrites,... -
(Table T2) Occurrence and depth of minerals in ODP sites 193-1188 and 193-1189
Sediment depth is given in mbsf. x = present, - = absent. -
(Table T1) Sulfide mineral occurrences in ODP Hole 209-1268A
Sediment depth is given in mbsf. Note: x = relative abundance of sulfide phases in each sample, t = trace, numbers are in visually estimated modal percent. -
(Table 13) Representative Fe-Ti oxide analyses of ODP Hole 126-791B and Alvin...
Cations based on 4 oxygens. -
(Table 8) Modal phenocryst mineralogy of rift basement ODP Leg 126 samples
Phenocrysts are >0.5 mm except for magnetite where >0.1 mm. X indicates >5% by volume; < indicates 1%-5%; - indicates not present. N indicates that the silicate... -
(Table 11) Basement andesite Fe-Ti oxides representative composition, ODP Hol...
The structural formula was calculated on the basis of 32 oxygenes.